Do it yourself

Hey Dale,drywall, and all of you! Many thanks for your suggestions on the stool replacement. Now there is just a few more things I need to understand and that is the yellow wax replacement. I have the wax in hand and the round ring with the screws in the floor around the hole - now what type of wax? what is core? Someone said that would keep the stool from moving around too much. I think drywall mentioned something about a vinyl filament to put on top of the floor before putting down the tiles. You mentioned tacking it - I think you said it was lightweight. I guess I am having a vision problem - do you make a hole for the stool? I was looking for the vinyl filament at HD but I didn't see it. Oh, do you know what isle you would find it on. It sounded like it was fairly good size is the vinyl material strong enough.. We have really done quite well - thanks to you all. Inners for the tank are put together and installed. Now we are just fine tuning the height of the water in the tank. Then we just need to go to the next part of the job. Oh, we did get water on the floor in the floor and everywhere else - it came out of the tank base. What a mess. The floor board is about 1/2 - 3/4" and I think it looks like sawdust combined composition?) Should we try to replace this composition board or just let it dry and then start with the vinyl laydown, grout (Or whatever is best) and then put down the tile. Won't the vinyl be inclined to move around? I remember drywall writing that vinyl came in many colors. Would it be put grout on floor and then put down the vinyl and then the tiles. Or vinyl tacked down then grout then tiles. (We bought the 12 x 12" multiple 1 1/2" square tile pieces which could be cut to fit better than the regular tiles. Well with you all helping - this job may be ready for the new wallboard - this got wet too - aren't we lucky? Yosemitejane3